Standing seam and metal panel roofing, roof repair and full replacement in Aurora. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
A coating buys real years on the right roof and wastes money on the wrong one. We will tell you honestly which kind you are looking at.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Aurora homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Aurora home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Why people around Aurora call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Straight answers to what Aurora homeowners ask us most often.
Much less than people expect. Over solid decking with underlayment under it, a Aurora metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Often, yes. Plenty of the Aurora roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Sometimes. If the decking is sound and there is only one layer of shingles, a Aurora metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Aurora houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
A typical Aurora shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Aurora metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Real feedback from homeowners whose roofs we have worked on.
"Honest people. I asked for a quote on a whole new roof and they told me mine had another eight years in it and just needed the valleys resealed. Who does that anymore?"
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Showed up when they said they would, both days. That alone puts them ahead of the last three contractors I hired."
Our crews cover the surrounding area, not only the city limits.